NEW Jeep Tan "The Rock" Transponder Ignition Lock Key / Fits Listed Models Chip

Description: New Replacement Transponder Ignition Key Includes One Genuine Jeep Rock Ignition Lock Key From Strattec NOTE: This is a transponder key. If you have a Jeep model listed above that has a factory transponder key, this key will require programming before it can be used to crank your Jeep. This can be done by your local locksmith or dealership, or if you have two working keys already, you can do it yourself following the instructions below. Obviously, the key must be professionally cut before these steps will work. If you have an earlier model Jeep listed above that does NOT use a transponder key, you don't need to do anything except have the key professionally cut. It will work fine. ------------------------ ADD KEY (Must have two working Sentry Keys): 1.Put one of the two current keys into the ignition and turn to the ON position. 2.After the key has been in the ON position for at least three seconds — but no more than 15 seconds — turn the key back to the OFF position. 3.Take the key out and put in the second current key, turning it to the ON position, all within 15 seconds. The second key cannot be the same as the first key. 4.After ten seconds, a theft alarm light will illuminate and a single chime will sound. This confirms entry into “Customer Programming Mode”. 5.Within 60 seconds, turn key OFF and remove the current key. 6.Put a new key into the ignition and turn to the ON position. 7.After ten seconds, a single chime will sound. The theft alarm light will turn off. Wait three seconds and turn key OFF. 8.Repeat these steps for additional keys.

Price: 29.99 USD

Location: Lafayette, Louisiana

End Time: 2023-09-08T20:24:24.000Z

Shipping Cost: 0 USD